General safety advice for electrical power tools / Operation
operating the device and to anyone near the work area.
Wear a dust mask!
WARNING! NOXIOUS FUMES! Ensure that there is adequate ventilation when machining surfaces containing plastic or cov- ered with paint, varnish etc.
Do not soak the materials or the sur- face you are about to work on with liquids containing solvents.
Avoid abrading paints containing lead or other substances hazardous to health.
Do not machine materials containing asbestos. Asbestos is a known carcinogen. Do not machine moist materials or damp surfaces.
NOTE! Do not allow the tool to come to a standstill by overloading it!
WARNING! Switch the device off and allow it to come to a standstill be- fore you put it down.
WARNING! Always keep the device clean, dry and free of oil or grease. Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device.
Operation
Never use the device for a purpose for which it was not intended or with
Inserting or replacing a tool / collet
Press the spindle lock 6 and keep it pressed. Rotate the clamping nut 4 until the lock engages.
Loosen the clamping nut 4 with the combina- tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use though the clamping nut 4 before you insert it into the collet 18 suitable for the tool shaft.
Press the spindle lock 6 and keep it pressed. Insert the collet 18 into the threaded insert and tighten the clamping nut 4 on the thread using the combination key 23 .
Using the Insertion tool with mandrel 12 : NOTE: Use the screwdriver end of the combi- nation key 23 to release or tighten the screw of the mandrels 12 .
Insert the mandrel 12 into the electrical tool as described.
With the aid of the combination wrench 23 , unscrew the screw from the mandrel 12 . Place the insertion tool you wish to have onto the screw between the two washers.
With the aid of the combination wrench 23 , tighten the screw on the mandrel 12 .
Switching on and off /
Setting the speed range
Switching on / Setting the speed range:
Connect the plug 3 to the power supply unit 9 by inserting it into the
Connect the device to the power supply by inserting the mains plug into the socket.
Set the ON / OFF switch | 1 | to a position |
between “5” and “20”. |
|
|
Switching off: |
|
|
Set the ON / OFF switch | 1 | to position “0”. |
10 GB/IE
