![](/images/new-backgrounds/1240376/24037631x1.webp)
Use of accessories
Cup brush, twisted wire
Dimensions: | ø 75 mm |
Speed: | min. 12000 rpm |
Other accessories
You can also use abrasive consumables and tools |
|
| |
complying with the following technical specification: |
|
| |
Spindle thread: | M14 | Cup brush, knotted wire | |
Speed: | min. 12000 rpm | Dimensions: | ø 115 mm |
Backing plate for grinding discs | Speed: | min. 12000 rpm | |
Dimensions: | ø 115 mm / 125 mm |
|
|
Grinding discs for wood / masonry attached |
|
|
|
|
|
|
|
|
|
|
|
| |
with hook and eye fixings | Adjusting the disc guard cover | ||||||||||||
Dimensions: | ø 115 mm / 125 mm | ||||||||||||
|
|
|
|
|
|
| DANGER OF INJURY! | ||||||
|
|
|
| WARNING! | |||||||||
|
| Pull the mains plug out of the mains socket | |||||||||||
|
| before you carry out any task on the device. | |||||||||||
|
| DANGER OF INJURY! Always use the an- | |||||||||||
|
| gle grinder with the disc guard cover | 5 | in | |||||||||
|
| place. The disc guard cover must be securely | |||||||||||
|
| attached to the angle grinder. To ensure the | |||||||||||
Note! These may only be used in combination | highest level of safety while using the device, | ||||||||||||
with a backing plate! |
| ensure that the smallest possible area of the | |||||||||||
|
| grinding or cutting tool is exposed to the oper- | |||||||||||
Cup brush, crimped wire | ator at all times (see Fig. B, C). The disc guard | ||||||||||||
Dimensions: | ø 75 - 100 mm | cover | 5 | is there to protect the operator from | |||||||||
Speed: | min. 12000 rpm | pieces breaking off and accidental contact | |||||||||||
|
| with the grinding or cutting tool. The disc guard | |||||||||||
|
| cover has 5 set positions. | |||||||||||
|
| Turn the disc guard cover | 5 | into the desired | |||||||||
|
| position (working position). The closed side of | |||||||||||
|
| the disc guard cover | 5 | must always be facing | |||||||||
|
| the operator. |
16 GB/IE