Partner Tech P33XT, P4-20XT, P4-18XT Declaration of Conformity, Troubleshooting Table Cause Remedy

CAUTION: It is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel fil- ter, fuel hose, or fuel tank during storage. Al-

cohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to fuel mixture separation and formation of acids during storage. Acidic gas can damage the engine.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

TROUBLE	CAUSE		REMEDY
Engine will not	1.	Ignition switch off.	1. Move ignition switch to ON.
start or will run	2.	Engine flooded.	2. See “Difficult Starting” in
only a few	3.	Fuel tank empty.	Operation Section.
seconds after			3. Fill tank with correct fuel mixture.
starting.	4.	Spark plug not firing.	4. Install new spark plug.
	5.	Fuel not reaching	5. Check for dirty fuel filter; replace.
		carburetor.	Check for kinked or split fuel line;
			repair or replace.
Engine will	1.	Idle speed requires	1. See “Carburetor Adjustment” in the
not idle		adjustment.	Service and Adjustments Section.
properly.	2.	Carburetor requires	2. Contact an authorized service dealer.
		adjustment.
Engine will not	1.	Air filter dirty.	1. Clean or replace air filter.
accelerate,	2.	Spark plug fouled.	2. Clean or replace plug and regap.
lacks power,	3.	Chain brake engaged.	3. Disengage chain brake.
or dies under	4.	Carburetor requires	4. Contact an authorized service dealer.
a load.		adjustment.
Engine	1.	Too much oil mixed with	1. Empty fuel tank and refill with
smokes		gasoline.	correct fuel mixture.
excessively.
Chain moves	1. Idle speed requires		1. See “Carburetor Adjustment” in the
at idle speed.		adjustment.	Service and Adjustments Section.
	2. Clutch requires repair.		2. Contact an authorized service dealer.

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)

We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy. Tel: +39--0341--203211, declare that the chain saw models Partner P33XT, P351XT, P4-18XT and P4-20XT CSI---AVfrom serial numbers 2007--151(N or D) 00001 and onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVES:

of 22 June 1998 “relating to machinery” 98/37/EC, annex IIA;

of 3 May 1989 “relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements; and

of 8 May 2000 “relating to the noise emissions in the environment” in accordance with Annex V of 2000/14/EC. The measured sound power is 110 dB(A), the guaranteed sound power is 118 dB(A) and the net power is 1,1 kW, 1,2 kW or 1,3 kW.

The following standards have been applied: ISO 11681-1:2004, EN/ISO 12100-1:2003,

EN/ISO 12100-2:2003, and CISPR 12:2001.

Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3 S--754

50 Uppsala, Sweden, has carried out EC type approval. The certificate(s) is numbered: 404/07/1193.

The supplied Chain Saw conforms with the sample that underwent the EC type approval.

07--05--31

Michael S. Bounds, Director

Product Safety and Standards

Handheld Consumer Products

14