Patton electronic 07M2160-QS Additional information Compliance Information, Telnet configuration

2.2 Serial console configuration

For configuring the Model 2160 through the serial console, connect a terminal or a PC equipped with a terminal- emulation program (such as Hyper Terminal) to the Model 2160's console port.

Use the supplied serial cable (RJ-45 to DB9F) to connect the Model 2160 to a PC. After marking the connection, configure the terminal-emulation program using the following parameters: 9600 bps , 8 data bits , no parity and 1 stop bit.

2.3 Telnet configuration

Make sure that an Ethernet Adapter has been installed in the PC or NB you will use to configure the Ethernet extender. The Model 2160 also supports Telnet for remote configuration. The command is “telnet 192.168.1.1”

. For logging into the system through a Telnet connection, “admin” for username and “admin” for password. The default IP address is 192.168.1.1. You may change the IP address for your application.

3.0 Additional information

For detailed information about installing, configuring, operating, and troubleshooting your Model 2160, refer to the Model 2160 Getting Started Guide on the enclosed Patton CD-ROM or at www.patton.com/manuals.

A.0 Compliance Information

A.1 Compliance

EMC:

•FCC Part 15, Class A

•EN55022, Class A

•EN55024

A.2 Radio and TV Interference (FCC Part 15)

This equipment generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and television recep- tion. This equipment has been tested and found to comply with the limits for a Class A computing device in accor- dance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interference will not occur in a particular installation. If the equipment causes interference to radio or television reception, which can be determined by disconnecting the cables, try to correct the interference by one or more of the fol- lowing measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna, and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches).

4 Model 2160 Series Quick Start Guide