Patton electronic 1082/F user manual Operation, Power-Up, LED Status Monitors, Los

5.0 OPERATION

Once the Model 1082 is properly configured and installed, it should oper- ate transparently. This sections describes power-up, reading the LED status monitors, and using the built-in loopback test modes.

5.1 POWER-UP

To apply power to the Model 1082, first be sure that you have read “Con- necting Power” on page 18, and that the unit is connected to the appro- priate power source. Then power-up the unit.

5.2 LED STATUS MONITORS

The Model 1082 features six front panel LEDs that monitor power, the DTE signals, network connection and test modes. Figure 10 shows the front panel location of each LED. See also, LED description Table 2.

NetLink™ 64k/G.703 iDSL Modem

Link	Status					Test Modes
DSL G.703	LOS	NS	ER	TM	Local	511E
					Normal	Normal
					Remote	511

	DSL LOS	TM	Loopback
	G.703	NS ER	switches
	Figure 10. Model 1082 front panel
	Table 2: LED descriptions
DSL Link	(Active Green) Solid green (On) indicates that the end
	to end DSL Framer Link is up, signifying that the link
	across the DSL span is active. The DSL Link LED is Off
	when the link is down.
G.703	Active green (ON) indicates valid G.703 data is
	present.
LOS	Active red (ON) indicates no valid G.703 data is
	present.
NS	(No Signal) glows red to indicate that the local Model
	1082 is not connected with the remote Model 1082.
ER	Blinks ON/OFF after a 511/511E test has received an
	error. See “Using the V.52 (BER) test pattern genera-
	tor” on page 23 for more information.
TM	Glows yellow to indicate TM

20