Patton electronic 1093 user manual Connection to the Twisted Pair Interface, Signal

Switch S1-8: V.54 Enable / Disable

The setting for switch S1-8 determines whether the Model 1093 will respond when it receives the V.54 sequence. If you suspect the Model 1093 may be getting tricked into the loopback test by false detection of user data, you can try setting this to “Disable.”

S1-8	Setting
On	Disabled
Off	Enabled

3.1.2 Switch Set S2

The settings for DIP switches S2-1 through S2-4 determine the synchronous data rate of the Model 1093. All possible settings (includ- ing the default) are shown below:

S2-1	S2-2	S2-3	S2-4	Setting
Off	On	On	On	256 kbps
On	Off	Off	Off	512 kbps (default)

4.0 INSTALLATION

Once the Model 1093 is properly configured, it is ready to connect to the twisted pair interface, to the serial port, and to the power source. This section tells you how to make these connections.

4.1 CONNECTION TO THE TWISTED PAIR INTERFACE

The Model 1093 supports communication between two terminal devices at distances to 6 miles and data rates to 512 kbps. There are two essential requirements for installing the Model 1093:

1.These units work in pairs. Therefore, you must have one Model 1093 (or a compatible model) at each end of a two twisted pair interface.

2.To function properly, the Model 1093 needs two twisted pairs of metallic wire. These twisted pairs must be unconditioned, dry, metallic wire, between 19 and 26 AWG (.4 mm and .9 mm, inversely) (the higher AWG gauges may limit distance somewhat). Standard dial-equalization equipment, or standard, flat modular telephone type cable, are not acceptable.

4.1.1TWISTED PAIR CONNECTION USING RJ-45

The Model 1093 uses a modular RJ-45 jack for twisted pair line con- nection. The signal/pin relationships are shown below:

RJ-45	SIGNAL
1	XMT+
2	XMT-
		1
3	N/C	2
4	GND*	3
		4
5	GND*	5
		6
6	N/C	7
		8
7	RCV+
8	RCV-
*Connection to ground is optional

7 8