Patton electronic 1180/35 General Information, Features, Description, Configuration, On Off

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected by Patton's qualified technicians. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Technical Support at (301) 975-1007.

2.1FEATURES

•Communicates full duplex over a single multimode fiber

•Synchronous data rates to 256 Kbps

•Hardware and software flow control support

•Internal, external or received recover clock

•Distances to 1.5 miles (over 64 Kbps)

•Distances to 3 miles (64 Kbps and under)

•ST or SMA fiber connectors

•V.35 DTE interface with female M/34

•Local and remote loopback diagnostics

•Tri-State front panel LED indicators

•Made in USA

2.2DESCRIPTION

The Model 1180/35 Single Fiber V.35 Short Range Modem accomplishes full duplex, point-to-point V.35 communication over a single multimode fiber. Supporting synchronous data rates up to 256 Kbps, the Model 1180/35 automatically adapts to hardware or software flow control, and can be set for internal, external or received recover clocking.

The Model 1180/35 features extended data rate circuitry that allows for single fiber distances up to 1.5 miles at data rates above 64 kbps, or 3 miles at data rates below 64 kbps. Both local and remote loopback tests can be activated from the front panel, or from the V.35 interface. The Model 1180/35 front panel incorporates LED indicators for TD, RD, RTS, CD and power.

Optical fiber may be connected to the Model 1180/35 using an ST or SMA type interface. The V.35 DTE interface on the Model 1180/35 is a female M/34 connector.

3.0 CONFIGURATION

The Model 1180/35 uses an eight switch package that allow s configuration to a wide range of synchronous applications. Because all eight switches are externally accessible (see Figures 1 and 2, below), there is no need to open the Model 1180/35's case for configuration.

FRONT

REAR

Figure 1. Switch Locations Underneath Model 1180/35

ON

OFF

Figure 2. Close-up of 1180/35 DIP Wwitch Package Showing OFF/ON Positions

3.1 DETAILED SWITCH SETTINGS

The Model 1180/35’s configuration switches set data rate (distance), sync clock source, and DTE control of the RDL and LAL test modes. The table on the following page summarizes the default switch settings for the Model 1180/35. Following this table is a detailed description of each switch function.

3 4