Manuals / Patton electronic / Computer Equipment / Switch

Patton electronic 2124, 2130 user manual Power Connection, AC Power Supply 100-240VAC

Models: 2130 2124

1 24

Download 24 pages 30.09 Kb

Page 10

4.2 POWER CONNECTION

4.2 POWER CONNECTION

The Model 2124/2130 offers either an AC or DC power supply.

The 2124/2130 provides a strap selectable power supply.

AC Power Supply (100-240VAC)

The Model 2124/2130 uses a 5VDC, 2A universal input 100-240VAC, power supply (center pin is +5V). The universal input power supply is equipped with a male IEC-320 connector. This power supply connects to the Model 2124/2130 via a barrel jack on the rear panel. A variety of international power cords are available for the universal power supply.

The Model 2124/2130 powers up as soon as it is plugged into an AC out- let. The unit does not have a power switch.

The 2124/2130 is factory set to be used with the AC power supply.

Note Default setting has strap on position 7 and 8 on J3 for AC power

supply. See Figure 4 below.

9

Image 10

Patton electronic 2124, 2130 user manual Power Connection, AC Power Supply 100-240VAC

Contents

MODEL 2124/2130 Ethernet MicroBridge USER MANUALAn ISO-9001 Certiﬁed Company TABLE OF CONTENTS 1.0 WARRANTY INFORMATION 1.1 RADIO AND TV INTERFERENCE1.3 SERVICE 1.2 CE NOTICE2.0 GENERAL INFORMATION 2.1 FEATURES2.2 DESCRIPTION 3.0 PPP OPERATIONAL BACKGROUND 3.1 APPLICATIONSFor example, the customer site is assigned the addresses 192.168.1.0/ 24 through 192.168.1.1/24. The address 192.168.1.1/24 is also the default gateway for the remote network. The above settings remove any routing/forwarding intelligence from the CPE. The associated Cisco con- ﬁguration will set serial interface s0 to accommodate half bridging for the above example Figure 2. Transparent bridging between two routers over a serial link Connect the 10BaseT Ethernet Port to a Hub 4.0 INSTALLATION4.1 CONNECT TO 10BASET ETHERNET PORT Connect the 10BaseT Ethernet Port to a PC DTE4.2 POWER CONNECTION AC Power Supply 100-240VACDC Power To Power Supply JackPower-up 2124 via DB-25 Connector on Pin WARNING support@patton.com Power-up 2124 via DB-25 Connector on PinPower-up 2130 via DB-25 Connector on Pin Power-up 2130 via DB-25 Connector on PinFigure 7. Strap positions 3 and 4 on J3 5.1 LED STATUS MONITORS 5.0 CONFIGURATIONLAN side LEDs Power and DCE/DTE interface LEDs LED DescriptionsPWR- LED green turns ON as soon as power is applied to the 2124 APPENDIX A PATTON ELECTRONICS MODEL SPECIFICATIONS APPENDIX B PATTON ELECTRONICS MODEL SPECIFICATIONS APPENDIX C 2124/2130 FACTORY REPLACEMENT PARTS DescriptionSignal APPENDIX D 10BASET INTERFACE PIN ASSIGNMENT RJ-45 FEMALE CONNECTORDTE CONFIGURATION Pin #Signal DB-25 MALE CONNECTORAPPENDIX E V.24 TERMINAL INTERFACE PIN ASSIGNMENT Pin #Signal APPENDIX F EIA-530 TERMINAL INTERFACE PIN ASSIGNMENTDB-25 MALE CONNECTOR Pin#Via 5VDC power jack J1 Center Pin +5VDC @ 500 mA minimun APPENDIX G POWER SUPPLY INTERFACEOuter Barrel Ground Copyright Patton Electronics Company All Rights Reserved