Manuals
/
Patton electronic
/
Computer Equipment
/
Switch
Patton electronic
2130, 2124 user manual Strap positions 3 and 4 on J3
Models:
2130
2124
1
13
24
24
Download
24 pages
30.09 Kb
10
11
12
13
14
15
16
17
<
>
Specs
Install
APPENDIX C 2124/2130 FACTORY REPLACEMENT PARTS
Warranty
Configuration
For example, the customer site is assigned the addresses 192.168.1.0/ 24 through 192.168.1.1/24. The address 192.168.1.1/24 is also the default gateway for the remote network. The above settings remove any routing/forwarding intelligence from the CPE. The associated Cisco con- figuration will set serial interface s0 to accommodate half bridging for the above example
Signal
Power Connection
Service
DB-25 MALE CONNECTOR
Page 13
Image 13
Figure 7.
Strap positions 3 and 4 on J3
12
Page 12
Page 14
Page 13
Image 13
Page 12
Page 14
Contents
MODEL 2124/2130 Ethernet MicroBridge
USER MANUAL
An ISO-9001 Certified Company
TABLE OF CONTENTS
1.1 RADIO AND TV INTERFERENCE
1.0 WARRANTY INFORMATION
1.2 CE NOTICE
1.3 SERVICE
2.0 GENERAL INFORMATION
2.1 FEATURES
2.2 DESCRIPTION
3.1 APPLICATIONS
3.0 PPP OPERATIONAL BACKGROUND
For example, the customer site is assigned the addresses 192.168.1.0/ 24 through 192.168.1.1/24. The address 192.168.1.1/24 is also the default gateway for the remote network. The above settings remove any routing/forwarding intelligence from the CPE. The associated Cisco con- figuration will set serial interface s0 to accommodate half bridging for the above example
Figure 2. Transparent bridging between two routers over a serial link
4.1 CONNECT TO 10BASET ETHERNET PORT
4.0 INSTALLATION
Connect the 10BaseT Ethernet Port to a Hub
Connect the 10BaseT Ethernet Port to a PC DTE
AC Power Supply 100-240VAC
4.2 POWER CONNECTION
To Power Supply Jack
DC Power
Power-up 2130 via DB-25 Connector on Pin
WARNING support@patton.com Power-up 2124 via DB-25 Connector on Pin
Power-up 2124 via DB-25 Connector on Pin
Power-up 2130 via DB-25 Connector on Pin
Figure 7. Strap positions 3 and 4 on J3
5.1 LED STATUS MONITORS
5.0 CONFIGURATION
LAN side LEDs
LED Descriptions
Power and DCE/DTE interface LEDs
PWR- LED green turns ON as soon as power is applied to the 2124
APPENDIX A PATTON ELECTRONICS MODEL SPECIFICATIONS
APPENDIX B PATTON ELECTRONICS MODEL SPECIFICATIONS
Description
APPENDIX C 2124/2130 FACTORY REPLACEMENT PARTS
DTE CONFIGURATION
APPENDIX D 10BASET INTERFACE PIN ASSIGNMENT RJ-45 FEMALE CONNECTOR
Signal
Pin #
APPENDIX E V.24 TERMINAL INTERFACE PIN ASSIGNMENT
DB-25 MALE CONNECTOR
Signal
Pin #
DB-25 MALE CONNECTOR
APPENDIX F EIA-530 TERMINAL INTERFACE PIN ASSIGNMENT
Signal
Pin#
Via 5VDC power jack J1 Center Pin +5VDC @ 500 mA minimun
APPENDIX G POWER SUPPLY INTERFACE
Outer Barrel Ground
Copyright Patton Electronics Company All Rights Reserved
