4.0 INSTALLATION
The 2124/2130 is equipped with Network, DTE, and power interfaces. This section briefly describes connnection to each interface.
4.1 CONNECT TO 10BASET ETHERNET PORT
The shielded
Figure 3. Model 2124/2130 Ethernet connector pinout
Connect the 10BaseT Ethernet Port to a Hub
The Model 2124/2130 10BaseT interface is configured as DTE (Data Terminal Equipment). Use the diagram below to construct a cable to con- nect the 2124/2130 to a 10BaseT Hub.
Connect the 10BaseT Ethernet Port to a PC (DTE)
The Model 2124/2130 10BaseT interface is configured as DTE (Data Terminal Equipment). To connect the 2124/2130 to another DTE such as a 10BaseT network interface card in a PC, construct a 10BaseT cross- over cable as shown in the diagram below.
8