3.0 INSTALLATION
Because the CopperLink Ethernet Extenders require no configuration, they can be installed quickly. Installation consists of the following:
•Connect the line interface between the units (refer to section 3.1, “Connecting the
Note See Figure 2 for the
•Connect the Ethernet interface (refer to section 3.2, “Line Interface— Connecting the
•Connect the power plug (refer to section 3.3, “Connecting Power” on page 11).
Figure 2. CopperLink Ethernet Extender rear panel
3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE
The Models 2156 and 2157 support communication between two peer Ethernet LAN sites over a distance greater than 30,000 ft (9,144 m) over 24 AWG (0.5 mm)
Note The Models 2156 and 2157 use an
8