Manuals / Patton electronic / Computer Equipment / Network Router

Patton electronic user manual User Manual, MODEL 2158B, CopperLINK Ethernet Extender

Models: 2158B

1 20

Download 20 pages 20.39 Kb

Page 1

USER MANUAL

USER MANUAL

MODEL 2158B

CopperLINK™ Ethernet Extender

This is a Class A device and is intended for use in a light industrial (commercial) environment only. It is not intended nor approved for use in a heavy industrial or residential environment.

Part# 07M2158B-UM

Rev. A

Revised 4/8/10

An ISO-9001Certiﬁed

Company

SALES OFFICE

(301)975-1000

TECHNICAL SUPPORT

(301)975-1007

Image 1

Patton electronic user manual User Manual, MODEL 2158B, CopperLINK Ethernet Extender, An ISO-9001Certiﬁed Company

Contents

MODEL 2158B USER MANUALCopperLINK Ethernet Extender Part# 07M2158B-UM Rev. A Revised 4/8/10Warranty Information CONTENTSInstallation ConfigurationDistance Chart, Based on 24 AWG 0.5 MM Low-Voltage Direcive Safety 1.0 WARRANTY INFORMATION1.1 REGULATORY INFORMATION EMC Directive 1.2 RADIO AND TV INTERFERENCE FCC PART1.3 CE DECLARATION OF CONFORMITY 1.5 SERVICE1.4 AUTHORIZED EUROPEAN REPRESENTATIVE Tel +1 301 Email support@patton.comFor AC powered devices which have 3 conductor 1.6 SAFETY WHEN WORKING WITH ELECTRICITYpower plugs L1, L2 & GND or Hot, Neutral must have an earth groundIn accordance with the requirements of council direc- tive 2002/96/EC on Waste of Electrical and Electronic Equipment WEEE, ensure that at end-of-life you sepa- rate this product from other waste and scrap and deliver to the WEEE collection system in your country for recy- cling 2.0 GENERAL INFORMATION 2.1 FEATURES2.2 DESCRIPTION CAUTION perature, ﬂammability, and mechanical serviceability 3.0 INSTALLATION The Interconnecting cables shall be acceptable forexternal use and shall be rated for the proper applica tion with respect to voltage, current, anticipated temThe Interconnecting cables shall be acceptable for 3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACEPower jack CopperLINK twisted-pair RJ-45 interface CAUTION perature, ﬂammability, and mechanical serviceabilityno connection 3.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE2 no connection 3 no connection4.0 CONFIGURATION 3.3 CONNECTING POWER4.1 CONFIGURING THE HARDWARE DIP SWITCHES 1 TX+/RX+Figure 6. DIP switch orientation Switch togglePower FrontS1-3 General Protection Signal to Noise Ratio 4.2 CONFIGURING DIP SWITCH S15.1 POWER UP S1-15.2 FRONT PANEL LED STATUS MONITORS PowerStatus DescriptionA.5 POWER SUPPLY A.4 LED STATUS INDICATORSA.6 TEMPERATURE RANGE A.8 DIMENSIONSPatton Model # APPENDIX BPower Supplies Power CordsC.1 10/100BASE-T INTERFACE RJ-45 APPENDIX CC.2 COPPERLINK INTERFACE RJ-45 Pin 1 TX+ Pin 2 TX Pin 3 RX+ Pin 6 RX Pins 4, 5, 7, 8 no connectionDistance in feet APPENDIX DThroughput Line RateCopyright Patton Electronics Company All Rights Reserved