Patton electronic 2510RC, 2520RC, 2500RC user manual Radio and TV Interference

		TABLE OF CONTENTS
	Section		Page
1.0	Warranty Information		2
	1.1	Radio and TV Interference
	1.2	FCC Information
	1.3	CE Information
	1.4	Service Information
2.0	General Information		5

2.1Product Features

2.2General Product Description

2.3Supported Applications

3.0 Configuration 7

3.1Front Card Configuration - Hardware Switches

3.2Front Card Configuration - Software Switches

3.3Rear Card Configuration

4.0 Installation 26

4.1The Model 1000R16 Rack Chassis

4.2Installing the Model 2500RC Series into the Chassis

4.3Wiring the Model 2500RC Series

5.0 Operation 28

5.1LED Descriptions

5.2Status Displays

5.3Loopback Test Modes

5.4The V.52 BER Test Pattern Generator

5.5Switched 56 Dialing Commands (Models 2510RC & 2520RC)

Appendix A - Specifications

Appendix B - Cable Recommendations

Appendix C - Factory Replacement Parts and Accessories

Appendix D - Interface Pin Assignments

Appendix E - Transmitter Clock Source During Test Loops

1

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 2500RC Series components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse, or unauthorized modification. This product contains no serviceable parts; therefore the user shall not attempt to modify the unit in any way. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user. In the event the user detects intermittent or continuous product malfunction due to nearby high power transmitting radio frequency equipment, the user is strongly advised to take the following steps: use only data cables with an external outer shield bonded to a metal or metalized connector; and, configure the rear card as shown in section 3.3. of this manual.

1.1 RADIO AND TV INTERFERENCE

The Model 2500 Series generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and television reception. The Model 2500 Series has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interference will not occur in a particular installation. If the Model 2500 Series does cause interference to radio or television reception, which can be determined by disconnecting the cables, the user is encouraged to try to correct the interference by one or more of the following measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna, and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches).In the event the user detects intermittent or continuous product malfunction due to nearby high power transmitting radio frequency equipment, the user is strongly advised to take the following steps: use only data cables with an external outer shield bonded to a metal or metalized connector; and, configure the rear card as shown in section 3.3.1 of this manual.

2