Patton electronic 2884 Console

Introduction 43

IpLink 2884/2888 Getting Started Guide C • Cabling

Introduction

This section provides information on the cables used to connect the IpLink and the interface cards to the exist-

ing network infrastructure and to third party products.

Console

The IpLink can be connected to a serial terminal over its serial console port, as depicted in ﬁgure 11.

Figure 11. Connecting a serial terminal

Note See section “Console port” on page 48 for console port pin-outs.

The interconnecting cables shall be acceptable for external use

and shall be rated for the proper application with respect to volt-

age, current, anticipated temperature, ﬂammability, and

mechanical serviceability.

CAUTION

Serial Terminal

Note A Patton Model 16F-561 RJ45 to DB-9 adapter is included with

each IpLink 288x device

Contents

Main IpLink 2884 T1/E1 Channelized Gigabit Router For Quick Important Page Summary Table of Contents Table of Contents Page Page List of Figures Page About this guide Audience Structure Precautions Safety when working with electricity General observations Typographical conventions used in this document Table 1. General conventions Convention Meaning Page IpLink Model 2884 Overview IpLink Model 2888 Overview Features and Benets Model 2884 Features Model 2888 Features Rear and Front Panels Figure 3. 2884/2888 rear panel IpLink 2884/2888 rear panel The IpLink 2884/2888 rear panel ports are described in table 3. Page IpLink 2884/2888 front panel Figure 4 shows IpLink 2884/2888 LEDs, the LED denitions are listed in table 4. Page Typical IPLink 2884 Application Page Chapter 3 IpLink installation Planning the installation Site log Network information Network Diagram IP related information Installing the IpLink 2884/2888 Placing the IpLink Installing cables Connecting the T1/E1 ports Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables Connecting the power supply Page Chapter 4 Initial conguration 1. Connecting the IpLink to your PC Connecting and logging in via the Ethernet port Connecting and logging in via the Console port 2. Conguring the desired IP address Factory-default IP settings Login Changing the IP address 3. Connecting the IpLink to the network Chapter 5 Contacting Patton for assistance Contact information Patton support headquarters in the USA Alternate Patton support for Europe, Middle East, and Africa (EMEA) Warranty Service and Returned Merchandise Authorizations (RMAs) Warranty coverage Out-of-warranty service Returns for credit Return for credit policy RMA numbers Shipping instructions Appendix A Compliance information Compliance EMC Safety PSTN Regulatory Radio and TV Interference Industry Canada Notice CE Declaration of Conformity Authorized European Representative Appendix B Specications WAN Ports Ethernet Ports Management Protocols Page Page Console Ethernet Figure 13. Typical Ethernet straight-through cable diagram for 1000Base-T Figure 12. Typical Ethernet straight-through cable diagram for 10/100Base-T E1 Port T1 Port Page This section provides pin-out information for the ports of the IpLink. Console port Conguration settings: 9600 bps, 8 bits, no parity, 1 stop bit, no ow control Figure 18. EIA-561 (RJ-45 8-pin) port Note N/C means no internal electrical connection. Ethernet T1/E1 port Appendix E End user license agreement End User License Agreement 1. Denitions 2. Title 3. Term 4. Grant of License 6. Termination 7. Other licenses