Patton electronic 3004 Service, telephone 301 email support@patton.com, Monday through Friday

1.3 SERVICE

All warranty and nonwarranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Return Materials Authorization number on the outside of the shipping container. This number may be obtained from Patton Electronics Technical Services at:

telephone: (301) 975-1007

email: support@patton.com

web address: http://www.patton.com

NOTE: Packages received without an RMA number will not be accepted.

Patton Electronics' technical staff is also available to answer any questions that might arise concerning the installation or use of your Patton Model 3004-MTE . Technical Service hours: 8AM to 5PM EST,

Monday through Friday.

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Technical Services at (301) 975-1007.

2.1FEATURES

·DCE to DCE connection

·Interface powered - No external power supply required

·Single 64-bit, auto-centering buffer

·Data rates up to 2.304 Mbps

·Available with male or female connectors and integral 6 foot cables

·Compact

·Easy to install

·Three models available:

3004-MTE/V.35- V.35 compatible. Male or female 34-pin V.35 connectors on 6 foot cables

3004-MTE/530- RS-422/V.11 compatible. Male or female 25-pin D-sub connectors on 6 foot cables 3004-MTE/V.36- RS-422/V.11 compatible. Male or female 37-pin D-sub connectors on 6 foot cables

2.2 DESCRIPTION

The Model 3004-MTE series are self-powered tail circuit buffers, which enable the connection of two DCEs in a "tail circuit" configuration. A tail circuit adapter is required to couple two DCE devices whose clocks are of the same frequency but are not in phase. The Model 3004-MTE utilizes a single auto-centering buffer to prevent data errors caused by clock jitter and clock phase differences. All models perform the necessary "cross over" wiring connections between the two DCEs. Installation is easy and straightforward.

3 4