Patton electronic 3125 manual Channel assignment, Configuring line settings and signaling for T1

Model 3125 RAS Getting Started Guide 3 • Configuring the RAS for operation

Note The information entered into the Interregister Signaling section must match the information the telco provided. If the information entered is not the same, the RAS may not answer calls. In some installations, the phone company will send a special tone to alert that it is done sending the Calling Number. In this case, the value in the Total Dig- its box does not have to match the telephone company’s exactly.

Channel assignment

This section describes configuring the RAS so it will know which channels are active. Do the following:

1.Select T1/E1 Link on the Configuration Menu. The T1/E1 Link Activity window appears (see figure 32 on page 49).

2.Click on Channel Assignment. The WAN Circuit Channel Assignment window appears (see figure 37).

Figure 37. WAN Circuit Channel Assignment window

3.Click on the Dialin button located under Set all channels to:.

4.Click on Submit Query.

Configuring line settings and signaling for T1

1.Select T1/E1 Link on the Configuration Menu. The T1/E1 Link Activity window appears (see figure 32 on page 49).

2.Link: 1 corresponds to Line 1 on the RAS. This is the primary link for dial-in callers. Under Link 1, Click on Configuration then Modify. The Line Interface Settings section of the WAN Circuit Configuration window appears (see figure 33 on page 49).

Configuring the line settings

1.Click on the Line Type pop-up menu (see figure 33 on page 49) and choose from the following options:

–dsx1ESF Extended SuperFrame DS1

Configuring the RAS with a Web browser 53