Patton electronic 4520 manual Login, Changing the IP address

Model 4520 & 4110 Series Getting Started Guide 4 • Getting started with the SmartNode

Login

Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to display. Type the factory default login: administrator and leave the password empty. Press the Enter key after the pass- word prompt.

login:administrator

password: <Enter>

172.16.40.1>

After you have successfully logged in you are in the operator execution mode, indicated by > as command line prompt. With the commands enable and configure you enter the configuration mode.

172.16.40.1>enable

172.16.40.1#configure

172.16.40.1(cfg)#

Changing the IP address

Select the context IP mode to configure an IP interface.

172.16.40.1(cfg)#context ip router

172.16.40.1(ctx-ip)[router]#

Now you can set your IP address and network mask for the interface eth0. Within this example a class C net- work (172.16.1.0/24) is assumed. The IP address in this example is set to 172.16.1.99 (you should set this to an unused IP address on your network).

172.16.40.1(ctx-ip)[router]#interface eth0

172.16.40.1(if-ip)[eth0]#ipaddress			172.16.1.99 255.255.255.0
2002-10-29T00:09:40	: LOGINFO	:	Link	down on interface eth0.
2002-10-29T00:09:40	: LOGINFO	:	Link	up on interface eth0.

172.16.1.99(if-ip)[eth0]#

Copy this modified configuration to your new start-up configuration. Upon the next start-up the system will initialize itself using the modified configuration.

172.16.1.99(if-ip)[eth0]#copy running-config startup-config

172.16.1.99(if-ip)[eth0]#

The SmartNode can now be connected with your network.

1. Configure IP address 49