Patton electronic 4520 Configure IP address, Power connection and default configuration, IP Address

4 • Getting started with the SmartNode Model 4520 & 4110 Series Getting Started Guide

1. Configure IP address

Power connection and default configuration

First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run' LED stops blinking and lights constantly. Now the SmartNode is ready.

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 8.

Table 8. Factory default IP address and network mask configuration

	IP Address	Network Mask
Interface Ethernet 0 (ETH0)	DHCP	DHCP
Interface Ethernet 1 (ETH1)	192.168.1.1	255.255.255.0

Both Ethernet interfaces are activated upon power-up.

If these addresses match with those of your network, go to section “2. Connect the SmartNode to the network” on page 50. Otherwise, refer to the following sections to change the addresses and network masks.

Connect with the serial interface

The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see figure 25) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate the terminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).

Link

VoIP

Power Run

Link

100M	Activity
0
Enet

Link

	Activity	0/0
100M
1
Enet

			VoIP
			Integrated
		4524
SmartNode
		ToIP
	0/2	0/3
0/1
	Ports
Voice

Router

GatewayDevice

Access

Console

Figure 25. Connecting to the terminal

Terminal emulation program settings:

•9600 baud

•no parity

•8 bit

•1 stop bit

•1 start bit

•No flow control

48 1. Configure IP address