Patton electronic 4830 Series Changing the IP address, 172.16.40.1if-ipeth0#ipaddress 172.16.1.10

SmartNode 4830 Quick Start Guide

3.Type administrator as the login prompt and press the Enter key after the password prompt (do not type anything for the password). A prompt will appear consisting of the IP address and > character.

login:administrator

password:

172.16.40.1>

4.Following log in, the SmartNode is in operator execution mode (indicated by > character in the command line prompt). With the commands enable and configure, you enter the configuration mode.

172.16.40.1>enable

172.16.40.1#configure

172.16.40.1(cfg)#

Changing the IP address

1.Select the context IP mode to configure an IP interface.

172.16.40.1(cfg)#context ip router

172.16.40.1(ctx-ip)[router]#

2.Set the IP address and network mask for the each IP interface (eth0, for example).

Note For the examples in this guide, a private network (172.16.1) IP address is used.

172.16.40.1(ctx-ip)[router]#interface eth0

172.16.40.1(if-ip)[eth0]#ipaddress 172.16.1.10 255.255.255.0

2002-10-29T00:09:40	: LOGINFO	: Link	down on interface eth0.
2002-10-29T00:09:40	: LOGINFO	: Link	up on interface eth0.
172.16.1.10(if-ip)[eth0]#

3.Make this modified configuration your new start-up configuration. On the next start-up the system will initialize itself using the modified configuration.

172.16.1.10(if-ip)[eth0]#copy running-config startup-config

172.16.1.10 (if-ip)[eth0]#

Go to section “Connecting the SmartNode to the LAN” on page 6 to connect the SmartNode to your network.

Connecting a PC, logging in, and configuring the LAN IP address 5

VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030