Patton electronic 5200 manual Typical Ethernet straight-through cable diagram

SmartNode 5200 Getting Started Guide C • Cabling

Introduction

This section provides information on the cables used to connect the SmartNode and the interface cards to the existing network infrastructure and to third party products.

Ethernet

Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All Ethernet ports on the SN5200 & SN4562 are Auto-MDX and use any straight or crossover cable to connect to hubs, switches, PCs or other devices.

	Hub
	Straight-through cable
RJ-45, male	RJ-45, male
1	1
2	2
3	3
6	6
	Note: Other pins are not used.

Figure 8. Typical Ethernet straight-through cable diagram

Introduction 40