Patton electronic manual SmartNode 5200 rear panel, WAN ETH 0/0

SmartNode 5200 Getting Started Guide 1 • General information

SmartNode 5200 rear panel

The SmartNode 5200 is a compact VoIP Gateway Router that supports 32 simultaneous SIP sessions. The SmartNode 5200 rear panel ports are described in table 2.

Model SN5200

WAN ETH 0/0		LAN (ETH 0/1)
Ethernet port	Ethernet ports 1–4

	Figure 2. SmartNode 5200 rear panel
	Table 2. Rear panel ports
Port	Description
WAN ETH 0/0	Auto-MDX Fast-Ethernet port, RJ-45 (see figure 2), connects the unit to an Ethernet WAN
	device (for example, a cable modem, DSL modem, or fiber modem).
LAN (ETH 0/1) 1–4	Switched Auto-MDX Fast-Ethernet ports, RJ-45 (see figure 2), connect the unit to an Ether-
	net LAN (for example, a PC, printer, or wireless bridge).
5V DC, 1.0A	The Model 5200 has a 5V DC power input (see figure 2).
Reset	The reset button (see figure 2) has three functions:
	• Restart the unit with the current startup configuration—Press (for less than 1 second)
	and release the Reset button to restart the unit with the current startup configuration.
	• Restart the unit with factory default configuration—Press the Reset button for
	5 seconds until the Power LED (see figure 3 on page 17) starts blinking to restart
	the unit with factory default configuration.
	• Restart the unit in bootloader mode (to be used only by trained SmartNode tech-
	nicians)—Starting with the unit powered off, press and hold the Reset button as
	you apply power to the unit. Release the Reset button when the Power LED starts
	blinking so the unit will enter bootloader mode.

SmartNode 5200 overview 16