Hang for
easy reference.
Monarch® 1103®-1110® Labelers
Operating Instructions
TC1000OI Rev. DF 1/08 ©2007 Paxar Americas, Inc. a subsidiary of LOADING LABELS & SETTING PRINT BANDS Avery Dennison Corp. All rights reserved.
LOADING LABELS
1label roll between hubs. Tear off
and discard first twelve labels and backing paper.If labeler has no label guide: Snap
If labeler has label guide: Snap label roll between hubs. Tear off and discard first twelve labels and backing paper. Then, insert label strip into guide slot as shown.
Label Guide | Guide Slot |
2operating lever half way,
and feed label strip under brake wheels.Squeeze and hold
Brake
Wheel
Operating Lever
3strip until about twelve
labels come out here. Release operating lever.Continue feeding label
a. Feed label strip up under 4 plate until two labels come
out here.
Plate
Loop
b. Squeeze operating lever halfway and rewind label roll until loop is removed.
5briskly toward operating lever,Grasp label strip and pull
separating labels from backing paper.
Discard separated labels.
6 | Tear backing paper as |
shown. |
Backing paper without labels
Straight tear 
between
7lever, exposing feedwheel. Insert backing paper into slot. When paper bows up, maintain finger
pressure and release operating lever.Completely squeeze operating
Slot
Feedwheel
8several times until backing paper exits labeler. If backing paper does not become taut and exit at rear, remove backing
paper from slot and repeat steps 6 and 7.Squeeze operating lever
SETTING PRINT BANDS
1 Pull knob until indicators point to desired band.
Indicators
2 | Turn knob until indicators point | 3 | Set all bands and push |
to desired character or blank. | knob in all the way. |
nMake sure the character you select is not a print character (UPSIDE DOWN). You should be able to read the character correctly through the band window.
INKING
1 Turn latch to release ink roll door and carefully pull it
completely out of labeler.
Latch
Ink Roll Door
2 Fold a piece of scrap backing paper.
3between ink roll and
carrier. Pull to snap old ink roll free. Insert folded backing paper
4 | Cut off end of new ink roll | 5 | Insert ink roll into ink door | 6 | Latch ink roll door securely. |
pouch. Using pouch to protect | opening. Tilt ink door |
| |||
fingers, slide carrier into pouch and | and press in . . . |
|
| ||
snap new ink roll into carrier (one side |
|
|
|
| |
at a time). |
|
|
|
| |
Lip
to place hinge tab under lip.
INKING
