MO9740 Manual

8. Printing Configuration Report

1.Hold down the feed button while turning on the power, until the printing motor becomes activated.

2.After feeding 12-inch blank media, the printing motor will suspend for one second, then it will print out the configuration profile. This profile states the firmware version, ROM checksum, RS232, thermal transfer/direct thermal settings, hardware configuration and font types.

3.With PPLB emulation, the printer will enter character dump mode. To exit from dump mode, just re-start the printer again.

MO9740 Manual

9. Reset the Printer to Factory Default

1.Turn on the printer and wait for 5 or more seconds.

2.Press the feed button for about 10 seconds; the ready indicator and the power indicator will then go off in order.

3.While both indicators are lit again, release the feed button.

4.At this point, the printer will begin to feed the label stock for approximately 12 inches in length, and return to the factory default settings.

Note :

All settings are stored in non-volatile E2PROM and cannot be destroyed even turn off the printer.

32

33