our patented DDT™ compression, which virtually eliminates audible power amplifier clipping. Cooling is via natural air convection - no noisy fan!
The combination of the
APPLICATIONS
The Peavey Impulse® 12D has a variety of applications, including sound reinforcement, public address, side fill system, karaoke and musical playback.
A typical signal source for the
REAR PANEL BOTTOM
1
3
2
CIRCUIT BREAKER (1)
The unit is AC power line protected from overloads and fault conditions with a 5 amp circuit breaker. This breaker should not trip unless there is a fault in the amplifier circuitry or an abnormal operating condition which causes excessive mains current to flow. If the breaker trips, set the Power switch (3) to OFF, wait a brief period of time for the breaker to cool, then reset the breaker.
If the circuit breaker trips, the center button will pop outward approximately 1/4”, and can be reset by pushing upward and inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it. The system should be taken to a qualified Peavey Service Center for repair.
IEC POWER CORD CONNECTION (2)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that you ensure the proper AC line voltage is supplied to the Impulse® 12D. You can find the proper voltage for your Impulse® 12D printed next to the IEC line (power cord) on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are properly grounded.
5