Connecting CD, Tape or Other Line Sources
Connect a CD or tape player to the CHANNEL 5 auxiliary input connectors (AUX IN) as shown (Fig. 8). If you wish to connect an additional tape machine, CD or other line source to the Escort, CHANNEL 5 also has stereo line inputs and CHANNELS
Fig. 8
Connecting Power
Before connecting power, make sure that the power switch is in the OFF position.
Connect the IEC power cord to the receptacle on the back panel of the unit as shown (Fig. 9, and then to a suitable electrical outlet. If an extension cord is used, be sure that it is a
NOTE: FOR UK ONLY
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: (1) The wire that is coloured green and yellow must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or coloured green or green and yellow. (2) The wire that is coloured blue must be connected to the terminal that is marked with the letter N, or the colour black. (3) The wire that is coloured brown must be connected to the terminal marked with the letter L, or the colour red.
Setting Controls and Turning Unit On
Set master controls to the 6 position and all other controls to 0. Turn on power by placing the OFF/ON switch, located next to the IEC cord receptacle (Fig. 9), in the ON position.
Fig. 9
Adjusting Gain and Volume Controls (Faders)
Adjust the channel GAIN controls (Fig. 10) for desired level from the speakers. If the desired level is reached with the channel GAIN at a low setting
Adjusting Tone Controls
Adjust the BASS and TREBLE controls (Fig. 10) as necessary to achieve desired sound. However, use moderation in setting channel tone controls. Extreme settings of these controls can adversely affect sound quality. Large amounts of boost (+) on these controls can also increase the chance of feedback on microphone inputs.
Reverb
Treble
Bass
Fig. 10
Fig. 11