Peavey 5150 manual Speaker Connection, Effects, Patching

Features and specifications subject to change without notice.

SPEAKER CONNECTION

When connecting the amplifier to the speaker enclosure, make sure to set the impedance selector switch on the rear of the unit to the impedance that matches your enclosure. When two enclosures of equal impedance are used, set the switch to one half the impedance of one enclosure (e.g. two 16 ohm enclosures: set switch to 8 ohms; two 8 ohm enclosures: set switch to 4 ohms). The 5150 is designed to operate into a minimum of 4 ohms.

00

u0 0 :,“:tCH

001 8 OHMS

00 SET SWITCH

00 TO 4 OHMS

00 8 OHMS

BACK PANEL

RACK MOUNT EFFECTS UNIT						EFFECTS
						PATCHING
						USING THE EFFECTS
FROM 5150						LOOP TO PATCH
EFFECTS SEND	FROM OUTPUT OF
						EXTERNAL, NON
OUTPUT TO INPUT OF
	RACK EFFECTS UNIT
RACK EFFECTS UNIT						GAIN PRODUCING
	TO 5150		EFFECTS
	RETURN		INPUT			EFFECTS	DEVICES
						(DIGITAL	DELAY,
		EFFECT(S)		ARE		REVERB,	CHORUS,
		;;;;;pM;fE’JSING				ETC . )
		FOOTSWITCH			(See
		section on		REMOTE
		FOOTSWITCH			JACK)

	FROM OUTPUT OF
ND	EFFECTSPEDAL
NPUT OF	TO 5150	EFFECTS
DAL	RETURN	INPUT

BACK PANEL