shorted across itself. Remember, just as in the stereo mode, the power LED array (Channel A) should reach 100% indication before the DDT system is activated on both channels.
3.The jumper plug in the transformer accessory socket (12) of channel A island can be replaced with a
4.The jumper plug in the crossover accessory socket (14) of the Channel A island can be replaced with a crossover or other
5.You should notice from Diagram 4 that crossover island B is completely isolated whenever bridge mode is selected, and it is normally not used. We leave its use to your imagination....
A Attention Mr. Service Technician:
If the time should ever come for you to service this power amplifier, it is important that you have the proper information on unit disassembly in order to gain access to the heat tube itself and all the associated circuitry. Our Service Department is ready to help you with any additional instructions on the correct service parts.
A
A
Warning:
There are no
Warning:
Voltage levels inside this amplifier could cause severe bodily harm. Always disconnect unit from mains power source and discharge major electrolytic capacitors before attempting to service. Additionally, the mains power source is switched by a mains triac, which is controlled by the front panel rocker switch. Mains power voltage is always present at this triac even with the switch off.
17