Peavey GPS Series UNPACKING/REGISTRATION, INSTALLATION AND MOUNTING, QUICK START, TO SET UP THE AMPLIFIER FOR BASIC USAGE:, AC POWER

Please read this guide in its entirety. Pay close attention to the various warnings within as they pertain to the

safety of you and your product. Each section will begin with a short description of the information you can

expect to obtain within. This should help you to locate the material you are looking for in a timely manner.

Once again, congratulations and thank you for buying Peavey!

UNPACKING/REGISTRATION

Inspect the amplifier during unpacking. If you find any damage, notify your dealer immediately. Be sure to

save the carton and all packing materials. Should you ever need to ship the unit back to Peavey Electronics,

one of its service centers, or the dealer, use only the original factory packing. Please fill out your registration

card at this time. It is important that you complete the entire form and mail it to Peavey Electronics in order

for your warranty to apply.

GPS Series amplifiers are 2-rack-space units that mount in a standard 19-inch rack. On all amplifiers, four

front panel mounting holes are provided. Refer to the specifications for your specific model in this manual.

The following section lists the steps for basic usage. This is only a quick reference. It is very important that

you read the entire manual in order to ensure the safe and optimum operation of your GPS Series amplifier.

1. Rack mount the amplifier in the location where it is to be used, remembering to allow for adequate

access and cooling space. For more information, see the section on Cooling Requirements.

2. Make input connections, balanced or unbalanced, to the combination input connector on the rear panel.

See the sections on The INs and OUTs of MODESELECTION for more information.

3. Connect speakers to the output jacks or binding posts. Be sure to make the correct output connections

for stereo or bridged mono configuration. See the section on The INs and OUTs of MODE

SELECTION for more information.

4. Make power connections, allowing for proper current draw. See the section on AC Mains Circuit Size

Requirements for more information.

5. Turn down (fully counterclockwise) the two gain attenuators on the front panel. Turn the front panel

AC switch to “ON,” and bring up the gain attenuators to the desired levels.

The following section will describe the AC power features of your GPS Series amplifier. AC power is a

critical element in power amplification. Please read this section carefully, paying special attention to any

warning signs. Refer to the diagram below and on page 8 to locate these features. Refer to page 7 for operation

notes regarding AC power.

NOTE: Always make connections to your GPS Series amplifier while the unit is turned off.

1. REMOVABLE AC POWER CORD(Located on the rear of the unit)

This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the

line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur

if an improper line voltage is used. (See voltage marking on unit.) Never remove or cut the ground pin

of the line cord plug. This unit is supplied with a properly rated line cord. When lost or damaged,

replace this cord with one of the proper ratings.