R E A R P A N E L

17

16

 

12

9

14

10

11 13

15

Main Line Out (9)

This low-noise‚ electronically-balanced XLR connector can be used to route signals to a mixing console‚ recording device‚ etc.

Send/Return Jacks Mains (10 & 11)

This pair of 1/4" jacks allow the use of various auxiliary units (effects units‚ equalizers‚ etc.) in-line‚ before the power amp section.

Headphone Jack (12)

This 1/4" jack accepts stereo headphones only.

CH4/Monitor Input Jack (13)

Use this 1/4" jack to connect to the output of any line-level device.

Channel: 3 Low-Impedance Input (14)

For use with low-impedance microphones or other line-level sources equipped with a male XLR connector.

Channels 3‚ 2 & 1 (15)

These 1/4" jacks accept high-impedance microphones or line-level sources equipped with 14" phone plugs.

External Speaker Jack (16) (KB3 only)

This 1/4" jack provides the powered signal from the amplifier. Use this jack to add a second speaker cabinet in parallel. The external minimum speaker load impedance is 8 ohms.

IEC connector/detachable line cord (17)

This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. The mains cord should be connected to the amplifier before connecting to a suitable AC outlet.

U.S. Domestic AC Mains Cord

The mains cord supplied with the unit is heavy-duty‚ 3-conductor type with a conventional 120 VAC plug with ground pin. Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin‚ a suitable grounding adapter should be used and the third wire should be properly grounded.

6

Page 6
Image 6
Peavey KB3, KB2 owner manual A R P a N E L