IN” input jack of the amplifier or mixer. Adjust the volume controls of the amplifier or mixer to the same desired level, then properly fine adjust the receiver volume control to match the same sensitivity as the wired microphone.
d.If the receiver output level is adjusted to a level that is near the maximum input level of the desired device, it will cause saturation distortion of the device when the receiver output level is increased due to a increase in level by the sound source. Conversely, S/N ratio will decrease if the receiver volume control is adjusted too low.
5.Plug the cable of the mains unit into DC socket on the receiver’s back panel. Thread the cable through the cable grip as shown in the figure below (Figure 10). The cable
grip prevents the connector from being pulled off by accident.
Figure 10
11