Peavey PV 10 Frequency Response, Total Harmonic Distortion, Hum and Noise, Crosstalk/Attenuation

Frequency Response

Mic Input to Left/Right Output 14 Hz to 25 kHz +0 dB/-1 dB

Total Harmonic Distortion

<0.02% 20 Hz to 20 kHz Mic to Left/Right Output (10 Hz to 80 kHz BW)

<0.005% Typical(22 Hz to 22 kHz BW) <0.0007% Mic Pre-amp Distortion

Hum and Noise

Output	Residual Noise	S/N Ratio (Ref: +4 dBu)	Test Conditions
Master Left/Right	-97 dBu	101 dB	Master Fader Down‚ Channel Levels Down
	-90 dBu	94 dB	Master Fader Nominal‚ Channel Levels Down
	-83 dBu	87 dB	Master Fader Nominal, Channel Faders Nominal,
			Panned Odd Channels (left), Even Channels (right)
Monitor Send	-95 dBu	99 dB	All controls off
	-80 dBu	84 dB	All channel sends nominal, masters nominal
Effects Sends	-100 dBu	104 dB	All controls off
	-80 dBu	84 dB	All channel sends nominal, masters nominal

(Hum and noise measurements: 22 Hz to 22 kHz BW)

Equivalent Input Noise (EIN)

-129 dBu (input terminated with 150 Ohms)

Crosstalk/Attenuation

Adjacent Input Channels (1 kHz)	>90 dB	Mute Button Attenuation (1 kHz)	>90 dB
Left to Right Outputs (1 kHz)	>75 dB	Channel Fader Kill (1 kHz)	>85 dB

Common Mode Rejection Ratio (Mic Input)

50 dB minimum (20 Hz to 20 kHz)

70 dB typical @ 1 kHz

Meters

8 segment, peak reading (0 dB = +4 dBu)

Signal/Overload Indicators

Red LED lights 3 dB below clipping

Dimensions

PV 10: 12.125" wide x 14.75" deep x 3.5" high (30.80cm x 37.47cm x 8.89cm)

PV 14: 16.125" wide x 14.75" deep x 3.5" high (40.96cm x 37.47cm x 8.89cm)

Installation Note:

This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"

Weight

PV 10: 9.3 lbs. (4.22 kg)

PV 14: 12.1 lbs. (5.49kg)

Power Requirements

PV 10: 100-240 VAC 50/60 Hz 13 Watts

PV 14: 100-240 VAC 50/60 Hz 17 Watts

15