Peavey VSX 26 manual Specifications, Analog Inputs, Outputs, Comments

VSX™ 26

SPECIFICATIONS

		Comments
Audio Channels	3 inputs/6 outputs	RTA Mic input can be summed with
		Line inputs.
LED Metering	2 inputs/6 outputs	LED STATUS:
		Red = -0.5 dBFS and higher (Clip)
		Red & Green = -4 to -0.5 dBFS
		Green = -4 to -40 dBFS
		Off = below -40 dBFS
Mute Function	Front panel switch and LED for each input and	LED STATUS:
	output	Red = Muted
		Off = On
ANALOG INPUTS
Input Trim Range	-6 to +6 dB	Software controlled
Line Sens Settings	+24 dBu or -10 dBV	Software selectable
Line Input Impedance	4.4 k ohms	Electronically balanced
Line Max In	24 dB
Line Input CMRR	55 dB
Line Input Crosstalk	-90 dB	20 Hz to 20 kHz
Line Input Dynamic Range	110 dB A-weighted	150 ohm input termination
RTA Mic Gain Range	+20 to +60 dB	Approximately 1/2 dB steps
RTA Max In	+2 dBu (.98Vrms)	Gain = 60 dB, 22K BW
RTA Input Impedance	2.2 k ohm	Electronically balanced
RTA Input CMRR	55 dB
RTA Input EIN	-128 dB A-weighted	150 ohm input termination
RTA Phantom Power	+48 volts	Software controlled
AES Input	On XLR 1	Software selectable between left
		channel analog line input
OUTPUTS
Output Full Scale	+24 dBu	Balanced
Output Impedance	150 ohms	Electronically balanced
Minimum Load Impedance	600 ohms	Maximum output @ 600 ohms =
		22.5 dBu
Dynamic Range	105 dB	A-weighted
ANALOG INPUT-TO-OUTPUT
Total Harmonic Distortion	0.007 %	20 Hz to 20 kHz, 22 kHz BW filter,
(+ Noise)		+4 dBu signal with 20 dB headroom
Frequency Response	20 Hz to 20 kHz	± 0.5 dBr referenced at 1 kHz
Dynamic Range	105 dB	A-weighted, 150 ohm input
		termination
Latency	< 1 mS	Propagation delay from input to
		output

17