Peerless Industries IM740P Tools Needed for Assembly, Table of Contents, Wall Construction, 2 of

Models: IM740P-S IM740P

1 6
Download 6 pages 26.43 Kb
Page 2
Image 2
WALL CONSTRUCTION

Note: Read entire instruction sheet before you start installation and assembly.

ADDITIONAL HARDWARE REQUIRED WARNING

Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-865-2112.

This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.

Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.

Never exceed the Maximum UL Load Capacity.

If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended.

Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.

This product was designed and intended to be mounted to the following supporting surfaces checked below with the hardware included in this product as specified in the installation sheet. To mount this product to an alternative supporting surface, contact Peerless customer care at 1 800 865-2112.

This product was designed to be installed on the following wall construction only;

WALL CONSTRUCTION

ADDITIONAL HARDWARE REQUIRED

x Wood Stud

None

Wood Beam

Contact Customer Service (Not Evaluated by UL)

Solid Concrete

Contact Customer Service (Not Evaluated by UL)

Cinder Block

Contact Customer Service (Not Evaluated by UL)

Metal Stud

Contact Customer Service (Not Evaluated by UL)

Brick

Contact Customer Service (Not Evaluated by UL)

Other or unsure?

Contact Customer Service (Not Evaluated by UL)

Tools Needed for Assembly

stud finder ("edge to edge" stud finder is recommended)

phillips screwdriver

drill

5/32" and 1/8" bit for wood stud wall

level

Table of Contents

Parts List

3

Installation to Wood Stud Wall

4

Installing Articulating Arm to In-wall Box

5

Attaching Screen

5

Cable Management

6

 

 

2 of 6

ISSUED: 12-04-07 SHEET #: 095-9280-3 03-25-10

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Page 2
Image 2
Peerless Industries IM740P Tools Needed for Assembly, Table of Contents, Wall Construction, Additional Hardware Required