Installing Adapter Brackets
WARNING
•Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become de- tached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
•If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly se- cured, damage may occur to screen or product may fail.
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
2 Place screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached. Place adapter brackets (BB) on back of screen, align to holes, and center on back of screen as shown below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws, wash- ers and spacers as shown in fi gure 2.1 or 2.2.
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
X
BB
CENTER BRACKETS VERTICALLY
ON BACK OF SCREEN
NOTE: "X" dimensions should be equal.
X
NOTE: For flat back screens proceed to step
6 of 34 | ISSUED: |
