For Flat Back Screen
Begin with the shortest length screw, hand thread through washer and adapter bracket into screen as shown | |
| below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over tighten. |
If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
fig. 2.1
SCREEN
WASHER
SCREW
ADAPTER
BRACKET (BB)
If you have any questions, please call Peerless customer care at
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into screen | |
| as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not |
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
SCREEN
SPACER
fig. 2.2
WASHER
SCREW
ADAPTER
BRACKET (BB)
If you have any questions, please call Peerless customer care at
7 of 34 | ISSUED: |
