6 of 20 ISSUED: 10-01-07 SHEET #: 095-9272-2 06-15-09
NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is
recommended to prevent the screen from slipping over time. If more or less tension is desired follow this optional step.
You may not achieve optimal torque value if factory torque settings are adjusted.
Ifmoreorlesstensionisdesiredintiltmechanism,removesnapcapsasshownindetail2.Insertaathead
screwdriverintoslotandprycapawayfromtiltmechanism:
• Toadjusttilt,simplytightenorloosensocketscrewnomorethanhalfaturnusing5mmallenwrench(E).
• Toadjustroll,simplytightenorloosen10-32nylocknut.
OPTIONAL
• Donotloosensocketscrewsornylocknutstothepointtheybecomedisengagedfromthemount.Doingsomay
cause the screen to fall.
WARNING
SNAPCAP
SOCKeT
SCREW
10-32NyLOCKNUT
DETAIL 2
SLOT
Ifmoreorlesstensionisdesiredinthearmpivotpoints,
dothefollowing:
•Toincreasetension,turnsocketscrewclockwisewith
3/16"allenwrench(I).
•Toreducetension,turnsocketscrewcounter-clockwisewith
allen wrench (I).
NOTE:Donotturnmorethanhalfaturn.
SOCKeTSCreWS
© 2009, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Peerless Industries, Inc.
3215W.NorthAve.
Melrose Park, IL 60160
www.peerlessmounts.com
Attach cable tie anchor (H) to top or bottom of wall arm (AA) using M4 screw (M)asshowningure3.1.Secure
cables to wall arm (AA) using cable tie (G)asshowningure3.2.
CordManagement
g.3.1 SCreeN
CABLES
M
H
3
AA
G
g.3.2