Installation to Wood Stud Wall
WARNING
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
1 | Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to |
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall |
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (65 mm) deep. Attach wall arm assembly (A) to wall using two #14 x 2.5" flat head wood screws (D) as shown.
Skip to step 2 on page 6.
WARNING
•Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
•Never tighten in excess of 80 in. • lb (9 N.M.).
•Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended.
WOOD
STUD
WALL
D
A
4 of 24 | ISSUED: |
