Installing and Removing Flat Panel Screen
3 | Attach screen to tilt assembly (B). Tighten M5 x 6 |
mm screw (H) to lock screen to tilt assembly. |
Note: For security models, use security driver (I) to tighten M5 x 6 mm screws (H).
To remove screen from mount, loosen screw (H) and lift screen off of mount.
WARNING
•Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely handle placement of the screen.
•Failure to lock adapter plate (A) with screw (H) can cause screen to come off mount if hit accidentally.
CAUTION
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 20 in. • lb (2.26 N.M.) maximum torque.
Adjusting the Tilt Angle of the Flat Panel Screen
4 | Adjust tension knob on right side of mount shown in |
figure 4 to desired tension to balance your screen |
size and weight.
Note: If knob is inaccessible, remove screen from mount, adjust tension knob to desired tension to balance your screen size and weight, and reattach screen to mount as stated in step 3.
Push or pull from top or bottom of screen to adjust tilt as shown in figure 4. The tilt can be adjusted to a maximum of 15° forward or 5° backward.
CAUTION
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
•Be careful not to pinch fingers when pushing screen from the bottom.
SCREEN
H
A
B
fig. 3
TENSION KNOB
fig. 4
7 of 7 | ISSUED: |
© 2007, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
