Installation to Single Wood Stud Wall
WARNING
•Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components.
1 | Use a stud finder to locate the edges of the stud. Use of an |
on its edges, draw a vertical line down the stud’s center. Place tilt assembly (B) on wall as a template, making sure |
that the two mounting holes are over the stud centerline. Level tilt assembly, and mark the center of the two holes. Drill two 5/32" (4 mm) dia. holes
Skip to step 2 on page 6.
WARNING
•Tighten wood screws so that tilt assembly is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
•Never tighten in excess of 80 in. • lb (9 N.M.).
•Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.
•Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.
B
G
4 of 7 | ISSUED: |
