Peerless Industries SUA746PU manual Display Washer Screw Adapter Bracket B Spacer

For Flat Back Display

2-1	Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
	display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a

longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

NOTE: If display manufacturer's requirements state that more than 1.27" of ventilation is required, spacers may be used to add an additional 0.75" of space between the wall and the display as shown below.

DISPLAY

WASHER

SCREW

ADAPTER BRACKET (B)

DISPLAY

SPACER

WASHER

SCREW

ADAPTER BRACKET (B)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

For Bump-out or Recessed Back Display

2-2	Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
	display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a

longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

DISPLAY
	WASHER
SPACER	SCREW

ADAPTER BRACKET (B)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

7 of 29 ISSUED: 10-24-11 SHEET #: 095-9364-1