Stroller Ganciomatic Hooks

SAFETY BELT

25• A: Make sure that the brace is properly inserted by pushing as shown in the figure. B: Fasten the belt as shown in the figure.

26• To unfasten the belt, press on the buckle sides and pull out the waist strap.

27• The new safety belt is now easier to fasten thanks to the "snap-open-and-shut" device. Before fastening the safety belt, attach the buckle to the backrest by inserting the tab through the special holder, as shown in the figure. After fastening the safety belt on your child, detach it from the backrest to allow the child more freedom of movement. The buckle must remain below the child's shoulders.

ADJUSTING THE FOOTBOARD

28• The footboard can be adjusted to three different positions. To lower the footboard, pull the two small levers downward while lowering. To lift the footboard, pull it up until it clicks into place.

ADJUSTING THE BACKREST

29• The backrest can be reclined in four positions. To lower the backrest, raise the handle as you lower the backrest, blocking it in the desired position.

To raise it, push the backrest upward.

SWIVELLING WHEELS

30• To make the front wheels swivel, push down as shown in the figure. To fix the wheels, pull up the lever.

SIDE DRINK HOLDERS

31• The stroller is equipped with two side drink holders that fold away or pull out as necessary. To pull the drink holders out, lift the upper part and lower the bottom part, as shown in the figure.

32• Turn the disk outwards, and place your drink in the holder. To clos e the drink holder, carry out the instructions in reverse order.

FOLDING UP THE STROLLER

Before folding the stroller, loosen the braces if the hood is attached, and raise the backrest if it is lowered.

33• The stroller can be folded up using one hand only, as follows. Place the stroller as shown in the figure. Pull the lever, turn the knob, and lower the handlebar. The stroller will automatically fold up.

34• Check the side safety hooks to make sure the stroller is correctly folded up. When folded up, the stroller will stand upright.

TRANSPORTING THE STROLLER

35• When folded up, the stroller can be carried by its side handle, as shown in the figure.

REMOVABLE LINING

36• To remove the strollerʼs lining, loosen the fasteners on the armrests as shown by the arrows.

37• Unbutton the sack at the side, as shown in the figure. Slip the leg divider on the safety belt out from under the seat.

38• Unbutton the sack from the seat and slip it off the footboard hooks. Slip the sack off the top of the stroller.

GANCIOMATIC SYSTEM

The Ganciomatic System is the swift, practical system that allows one to fasten the following products, which can be bought separately and are also equipped with Ganciomatic System, to the stroller, thanks to Ganciomatic fasteners.

• Primo Viaggio: a car seat with base, it can be

detached from its base (which stays in the car) and attached to the Ganciomatic fasteners of the stroller to transport your child without disturbing him/her.

•Navetta: the comfortable bassinet unit becomes a carriage when attached to the fasteners of the stroller. Equipped with a foldable hood and carrying handle, both the air circulation regulation system inside the bassinet and the inclination

of the backrest are adjustable from outside. At home, it rocks like a cradle and, when the stand is taken away, it becomes a little bed.

•Porte-Enfant GM: light and practical for carrying your child around, it turns into a carriage when attached to the Ganciomatic fasteners on the stroller, and, as it is not equipped with its own hood, it uses the reversible hood of the stroller. When your child is older, the padding turns into a second padded sack with hood to install on the stroller.

39• To raise the Ganciomatic hooks on the stroller, pull the sack up at the corners of the seat and turn the two hooks upwards until they click into place.

40• To lower the Ganciomatic hooks on the stroller, pull the little lever outwards and turn the hooks upwards at the same time, as shown in the figure.

A3 + PRIMO VIAGGIO

41• To fasten the car seat to the stroller:

-set the brake on the stroller;

-remove the hood from the stroller;

-completely lower the backrest on the stroller;

-raise the Ganciomatic hooks on the stroller;

-place the car seat, turned towards the adult, on the stroller and push downward until it clicks into place.

-Do not remove the front bar of the stroller when attaching the car seat, and make sure that it is in its original position.

•See the userʼs manual for instructions on how to detach the car seat from the stroller.

A3 + NAVETTA

42• To fasten the Navetta bassinet unit to the stroller, you must:

-put the brakes on the stroller;

-remove the hood from the stroller;

-lower the backrest of the stroller completely;

-raise the Ganciomatic fasteners on the stroller;

-remove the front bar and insert the plugs provided to close the armrests of the stroller;

-raise the footrest on the stroller to the highest possible position;

-hold onto the handle of the Navetta;

-position the Navetta on the Ganciomatic fasteners of the the stroller, keeping the head end of the bassinet at the end of the stroller opposite the handlebar;

-press down with both hands on the sides of the Navetta until you hear a click.

•To unfasten the Navetta bassinet unit from the stroller, consult its instruction manual.

A3 + PORTE-ENFANT GM

43• To fasten the Porte-Enfant GM to the stroller, you must: