Pelco C1306M-D (7/09) - page 19

C1306M-D (7/09) 19
3. Models with a wiper: Remove the wiper arm and the green bushing from the unit (refer to Figure 14).
4. Slide the camera module out of the enclosure.
5. Install the new camera module by doing the following:
Slide the camera module into the camera enclosure. Refer to Figure 15 to position the camera module properly in the camera enclosure.
Carefully mate the camera’s power connector to the mating connector located inside the camera enclosure.
Models with a wiper: The tab located inside the enclosure must be pointing down before installing the camera module (refer to
Figure 15). To position the tab, place the wiper, located at the front of the camera enclosure, in the center of the viewing window (refer to
Figure 16).
Figure 15. Install Camera Module
Figure 16. Center Wiper
WARNING: Never force the camera module into the enclosure.
CENTER
NOTCHES
TAB
CAMERA
MODULE
CAMERA
ENCLOSURE
CENTER WIPER