Pelco C1306M-D (7/09) - page 13

C1306M-D (7/09) 13
3. Slide the camera module into the camera enclosure. Refer to Figure 6 to position the camera module properly in the camera enclosure.
Carefully mate the camera’s power connector to the mating connector located inside the camera enclosure.
Models with a wiper: The tab located inside the camera enclosure must be pointing down before installing the camera module (refer to
Figure 6). To position the tab, place the wiper, located at the front of the camera enclosure, in the center of the viewing window (refer to
Figure 7).
Figure 6. Install Camera Module
Figure 7. Center Wiper
WARNING: Do not force the camera module into the camera enclosure.
CENTER
NOTCHES
TAB
CAMERA
MODULE
CAMERA
ENCLOSURE
CENTER WIPER