20 C1306M-D (7/09)
6. Models with a wiper: Refer to Figure 14 and do the following to reinstall the arm of the wiper:
a. Reinstall the green bushing on the stud located behind the handle of the camera module.
b. Reinstall the wiper arm. Place the ridge of the arm in the notch of the camera enclosure tab and the slot of the arm over the green
bushing.
7. Secure the camera module and the wiper arm with the 8-32 Phillips flat head screw (refer to Figure 14).
8. Reinstall the back cap on the camera enclosure by doing the following:
a. Use your hands to turn the back cap clockwise until you can no longer turn it with your hands. The back cap should turn easily until it
comes in contact with the O-ring. If it does not turn easily, the threads are not aligned and thread damage will occur.
b. Continue tightening the back cap with the supplied spanner wrench. There should be no gap between the back cap and the camera
enclosure when the back cap is tightened and properly installed.
c. After the back cap is installed, secure the back cap with the set screw using a 1.5 mm Allen wrench.
WARNINGS:
• To avoid thread damage, carefully install the back cap to the enclosure.
• Never force the back cap onto the end of the enclosure.
• When installation is completed, there should be no gap between the back cap and the camera enclosure.