C1306M (8/05) 15
Install the Enclosure and Set Pan Position 1. Lightly apply O-ring lubricant (supplied) to the O-ring, and then install the O-ring on the rim of the power module (refer to Figure 9).
Figure 9.
Lightly Lubricate and Install O-Ring
2. Refer to Figure 10 and attach the enclosure unit to the power module. Align the pins of the enclosure unit with the holes of the power
module. Carefully mate the enclosure connector to the power module connector.
Figure 10.
Attach the Enclosure Unit to the Power Module
3. Turn the body of the enclosure to the left or right to set the pan position of the unit.
4. With your hands carefully thread the enclosure’s locking ring on the threads of the power module until the threads are completely engaged.
5. Use the supplied spanner wrench to tighten the locking ring and fix the position of the enclosure. Make sure that the pan position is
maintained when tightening the locking ring. Tighten the set screw of the locking ring with the supplied 2 mm Allen wrench to secure the
locking ring.
WARNINGS:
•Total weight of the enclosure component is 34.7 lbs (15.71 kg). Use caution when lifting and assembling the pan and tilt component
on the power module.
• The weight of the enclosure unit must be safely supported during installation.
• It is recommended that non-slip gloves be worn during installation.
•Avoid thread damage. Never use force when assembling and tightening the threaded components of the system.
WARNING:
Do not turn the body of the enclosure more than 200° in either direction or damage to the internal power module cable may occur.
PIN
HOLE
LOCKING
RING