Pelco C1306M Install the Sun Shroud

C1306M (8/05) 17

Install the Sun Shroud

1. Place the supplied nylon washers on the 6-32 Phillips pan head screws. Refer to Figure 12.

2. Align the mounting holes of the sun shroud with the holes on top of the camera enclosure.

3. Use the supplied nylon washers and screws to secure the sun shroud to the camera enclosure.

Figure 12.

Install the Sun Shroud

NYLON

WASHER

6-32 PHILLIPS PAN

HEAD SCREW

SUN SHROUD

Contents

Main Contents List of Tables List of Illustrations Important Safety Instructions CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. Getting Started METHODS OF INSTALLATION Install the Power Module CONNECT WIRING Video Coaxial Cable Requirements Conguration of Wire Harness DIP SWITCH SETTINGS Switch Settings for SW3 BAUD SETTINGS (SW3) TERMINATION SETTING (SW2) Table A. P Protocol Receiver Address Table B. D Protocol Receiver Address Page Page Page Install the Camera Module Page Page Install the Enclosure and Set Pan Position Set the Tilt Angle of the Camera Module Install the Sun Shroud Maintenance CAMERA MODULE REPLACEMENT Page Page Specications GENERAL MECHANICAL ELECTRICAL CAMERA/OPTICS PRODUCT WARRANTY AND RETURN INFORMATION REVISION HISTORY