Pelco C1555M-F, C1566M-C, C1572M MODELS

C1555M-F (10/05) 7

MODELS

CM9700-CC1 CPU controller; 120 VAC, 60 Hz or 230 VAC, 50 Hz.

CM9700-SER Serial communication card (RS-422 SERCOM); provides 8 communications ports to interface peripheral equipment

(4 maximum per CPU).

CM9700-SER-32 Port expansion unit; 32 serial communication (SERCOM) ports per unit. Up to three units can be added to a CC1.

(Check with Pelco Systems Applications Department before adding to an existing CM9700-CC1). Includes

interconnecting cables and adapters for DB9 and RJ-45 connectors. Data interface can be RS-232 or RS-422.

NOTES ON USING THE SYSTEM CPU:

• You can use CM9760-CC1/CM9760-NW1 CPUs with the System 9770 if the CPU has been updated with software version level 9.01.XXX

(note that at this software level the ﬁrst three digits—9.01 in this case—must be at the same version level in the CPU (CC1 and NW1) and

in the MGR software; the remaining three digits, such as .001 in version level 9.01.001, can vary).

• Note, however, that software version level 9.01 requires a minimum of 16 MB of RAM in the CPU. If necessary, you can upgrade the RAM

in a CM9760-CC1 using the software upgrade kit appropriate for your CPU. Contact Pelco Technical Support at 1-800-289-9100 or

1-559-292-1981 for additional information.

CM9770-MXB Video matrix bay equipped with one CM9700-MPS power supply; 100-240 VAC, 50/60 Hz, autoranging.

CM9700-MPS Matrix bay power supply (spare); 120 VAC, 60 Hz or 230 VAC, 50Hz.

CM9770-DFC Downframe card and cable assembly; connects multiple matrix bays for expansion purposes.

CM9770-DFL Downframe card and cable assembly with BNC connectors for looping video.

CM9770-VCC Video camera card capable of accepting up to 32 camera inputs; also requires a rear panel card (CM9770-DFC,

CM9770-DFL, or CM9770-RPC).

CM9770-RPC Rear panel video card; provides 32 BNC connectors used to connect camera inputs to matrix bay.

CM9770-VMC Video monitor card providing 16 monitor outputs; requires CM9770-RPM.

CM9770-RPM Rear panel monitor card; provides 16 BNCs to connect monitor outputs to matrix bay; also interfaces video output

signals from video output card.

CM9700-VPP Video patch panel; provides 32 BNC connections for looping video out of system.

CM9700-VPP-RK Optional rack mount designed to hold up to 16 CM9700-VPP patch panels.

CM9700-NW1 Network interface unit; network CPU and software necessary for joining two or more independent systems together.