Pelco C1602M - page 15

C1602M (6/04) 13

3. Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that you

removed earlier.

4. Plug the power cord back into the power supply and then into the wall.

5. Turn on the power switch and allow the unit to start up and find the new memory. This may take several minutes.

Figure 12. Restarting the Unit

ON/OFF

Contents

Main Page Introduction Getting Ready Tools Needed Parts List Page Page Prepare Unit for RAM Installation OPEN THE UNIT CHASSIS Getting Ready C1602M (6/04) 7 COMPONENT LAYOUT Figure 6. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Page Page Page Page Verify Installation of New RAM Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: