Pelco C1692M - page 13

C1692M (12/05) 13

2. Remove the power connector from the system drive. Refer to Figure 9. If a second drive is installed in the basket,

remove the power connector to the second drive.

Figure 9.

Removing System Drive Power Connection

SYSTEM DRIVE

POWER CONNECTOR

Contents

Main Contents List of Illustrations Introduction TOOLS NEEDED Qty Description PARTS LIST Getting Ready Page Prepare Unit for Drive Installation OPEN THE UNIT CHASSIS Page COMPONENT LAYOUT REAR OF DVR FRONT OF DVR Move the Front Cross-Brace Page Disconnect the Data and Power Cables Page Page Replace the Primary Hard Disk REMOVE THE ORIGINAL SYSTEM DRIVE MOUNT THE NEW SYSTEM DRIVE Page SET THE SYSTEM PRIMARY JUMPER Page RECONNECT THE DATA AND POWER CABLES Page Page Page Page Page Page Page Page Install Software on the New Drive CONFIGURE SYSTEM TO BOOT FROM CD/DVD AwardBIOS Setup Utility Page AwardBIOS Setup Utility F1 Help ESC Exit Main Advanced Power Boot Exit AwardBIOS Setup Utility F1 Help ESC Exit Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATION REVISION HISTORY