Pelco C1692M , Introduction

4 C1692M (12/05)

Introduction

The following instructions provide step-by-step directions for replacing the primary hard disk drive of your DX8000 Series

digital video recorder (DVR).

PARTS LIST

NOTE:

This replacement kit includes a Pelco-certiﬁed hard disk drive. Using any other hard disk drive with the DX8000

voids the manufacturer’s warranty for the DX8000.

Qty Description

1 80 GB or 250 GB hard disk drive

2 Mounting screws

1 DX8000 Reinstallation CD

TOOLS NEEDED

1 Phillips-head screwdriver #1 (nonmagnetic)

1 Properly grounded ESD wrist strap and mat

4 Small containers for storing screws (optional)

Contents

Main Contents List of Illustrations Introduction TOOLS NEEDED Qty Description PARTS LIST Getting Ready Page Prepare Unit for Drive Installation OPEN THE UNIT CHASSIS Page COMPONENT LAYOUT REAR OF DVR FRONT OF DVR Move the Front Cross-Brace Page Disconnect the Data and Power Cables Page Page Replace the Primary Hard Disk REMOVE THE ORIGINAL SYSTEM DRIVE MOUNT THE NEW SYSTEM DRIVE Page SET THE SYSTEM PRIMARY JUMPER Page RECONNECT THE DATA AND POWER CABLES Page Page Page Page Page Page Page Page Install Software on the New Drive CONFIGURE SYSTEM TO BOOT FROM CD/DVD AwardBIOS Setup Utility Page AwardBIOS Setup Utility F1 Help ESC Exit Main Advanced Power Boot Exit AwardBIOS Setup Utility F1 Help ESC Exit Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATION REVISION HISTORY